About this deal
Includes a 1-1/2" and a 1-3/4" neck, weld-in 1/4" NPT fitting, hose barb and petcock. Fabrication and aluminum welding required. This kit is not recommended for plastic repairs or for use with polyethylene or polypropylene plastic parts. RadiatorWeld™ is a plastic tank and radiator repair kit designed for permanent or temporary repairs on both metal and plastic radiators and plastic liquid storage containers from leaks caused by cracks of 4" or less and holes up to 1/4" diameter. These aluminum hose neck kits make it easy to rebuild your aluminum radiator. Part: 32-34465
- 1-1/2" tube = 2-1/2" long
- 1-3/4" tube = 3" long
Reviews
Mark
Then I hand sanded it with a small piece of 100 grit sandpaper until the surface looked rough. After sanding the leaky area and then cleaning it thoroughly, you just combine the 2 parts in a bag, mix together and then paste the soupy mixture in place. Fantastic product. I then painted it with high heat spray paint and you can’t even tell a repair was made!
Jack Hart
Just to be safe I waited until the next day to drive the car. I have been driving the car around daily like normal.
It could not have been easier. Then I cleaned the area with a wet paper towel and dried it with a dry paper towel. Then I blew off the dust and cleaned it again with paper towels and made sure it was dry.
It was simple to use. Initially I wasn’t sure if this would work but I was happily surprised that it did. Then I applied the fiberglass mesh lightly pushing it into the epoxy. Then I cut my fiberglass mesh down to size.